[Shenzhen license plate recognition equipment customization] Nanshan automatic road gate maintenance and renewal
Time: 2020-05-07 View: 1457
[Shenzhen license plate recognition equipment customization] Nanshan automatic road gate maintenance and renewal
Nanshan automatic road gate maintenance and renewalCircuit maintenanceAccording to the previous use, check whether there is any problem in the electric control part. If there is no problem, check whether the power supply is exposed and bundled, and whether the wire is aged and replaced. Refer to the manual and check the parameters of each part. If there is a problem, we should follow the clues to find the source of the problem and replace individual electronic components.Internal movement maintenanceAs the heart of the machine, the movement of the gate must be kept in good condition. The maintenance frequency is generally once a month: first open the upper cover to cut off the power supply, clean the dust on the surface, first clean the transmission part, and then add butter or high concentration oil to make the treatment stable. Check whether the fasteners are loose, fasten the fasteners and check the wearing condition of vulnerable parts. If it is found that the wear degree exceeds the normal parts, it shall be replaced in time. Check whether the clearance between the positioning arm and the positioning plate is greater than 3mm. If any, replace it in time, add butter or oil to the solenoid valve core to reduce the resistance and make it smooth, but do not add too much, otherwise it will promote the growth. So as to affect the performance and mechanical life of the gatePrecautions for gate maintenance:1. Always remove the dust and sundries on the surface of the box and keep the surface of the gate clean.2. Check whether the fasteners are loose and fall off once a month, and fasten them in time.3. Take part in the activity every 3 months to connect the lubricating oil of accessories and keep it in good lubricating condition.4. Check the balance spring after 30000 times of operation and adjust the balance in time.5. Personnel are required to check the wear every 6 months and replace the worn parts in time.6. The remote control battery adopts DC12V, 23a battery, with a service life of one year. Pay attention to replace the battery, do not get wet, collide or collide. Nowadays, there is a growing demand for turnstiles7. Remote control interval is too short. Please check whether the installation position of the host is covered by metal or whether the battery power is sufficient.What are the debugging methods of the gate? The gate system is designed to deal with road entrances and exits that restrict the driving of motor vehicles. It has been widely used in road toll stations, parking lots, communities, enterprises and institutions to handle entry-exit vehicles.Before use, the gate can be used normally only after careful debugging. What are the commissioning methods of the gate? What do you know about gates? What do you know about the gate railing device and how to use the gate device? The following is a compilation of relevant information, I hope to help you. Door openWhen embedding cables, sufficient length shall be reserved to connect the ground sensor controller, and there shall be no joint in the middle. After winding the coil cable, the cable will be led out through the outgoing trunking. The output wires are tightly twisted in pairs, less than 20 weeks or longer in a meter. The length of the conductor shall not exceed 100 meters. As the sensitivity of detection coil decreases with the increase of wire length, the wire length should be as short as possible. After the coil is embedded, it shall be sealed with cement or asphalt.
