Customized installation of electric expansion door / automatic door remote control in Guangming district is convenient and fast
Time: 2020-06-23 View: 1405
Customized installation of electric expansion door / automatic door remote control in Guangming district is convenient and fast
automatic door remote control in Guangming district is convenient and fastInstall the expansion door. How to install the electric expansion door? How to install the electric expansion door step by step1: First, take out a piece of wood sealed by the wooden box from the end of the machine head, and then pull the door row out of the wooden box.2: After unplugging, find out the nose key. The key of the machine head is generally tied on the movable circular pipe of the horizontal bar at the end of the door row and bound with a bandage.3: Open the head cover with the key and take out the white box beside the motor. There are wireless remote control * 2, wireless console * 1, clutch key * 1.4: The function of the wireless remote control is to control the operation of the retractable door, which is small and exquisite and easy to carry. Console control is used for daily operation of security personnel and placed in the guard room.5: If "the gear rotates and the shaft rotates" appears during the operation of the remote control door body, it means that the motor clutch is not closed. Insert the hex clutch key into the shaft end of the motor harness chain. There is a concave hexagon groove. Insert the clutch key and rotate 180 degrees to open the clutch.6: After the motor debugging, close the door row to the wall (the position of the door body needs to be fixed). There are three fixed parts at the bottom of the end of the door body. The first is the corner code on the horizontal square tube in the middle of the door row, which can be fixed on the wallUpward square has a horizontal pipe at the bottom of the last line of the door, there are two stainless steel corner codes at the left and right ends of the internal aspects, which can solve the problem of the door body on the ground (suitable for installation position without wall column).7: After the door body and wall are closed, the central part of the door body shall prevail (i.e. assuming your door width is 80 cm)The circular magnet is installed at 40 cm) position, a circular magnet is buried every 20 - 25 cm along the straight line in the middle part of the door from the edge to the edge of the wall (note that when the magnet is buried, all embedded magnetsIron, including square magnets, needs to be completely buried on a polar surface [that is, if the first magnet is buried in the same phase, then the magnets installed at the back need to be buried in the same phase])8: After the circular magnet is embedded, bury a square magnet (limit stop body of the control door) directly below the stop position of the head, and the row door is closed (corresponding position is the head at the bottom of the Black clamp (limit Navigator))9: The body behind the door is fully extended, burying a square magnet directly in front of 30 to 100 mm (i.e. close to 30 to 100 cm from a part of the head needs to stop) and a part of the head needs to stop.10: At 1000mm away from the door and the wall, the next one is buried at the bottom of the head (corresponding to the white pipe [infrared reed pipe]) and 150MN away from the circular magnet (middle of the track)Square magnet (subject to the return end point of the door without resistance, note: [if the expansion door with infrared anti-collision is fixed with infrared magnet, only the door row will not automatically shrink during the closing process])11: The voltage of 220V power supply (two room power supply) shall not be less than 180 pairs, and the three power lines respectively correspond to red (with wire), yellow (ground wire) and blue (zero wire). Three wires are connected (the ground wire may not be connected), and it is finished!
